Thermon PCA-COM Manuel d'utilisateur télécharger pdf (Page 4)

1.9. Cutandremoveprimaryinsulationjacket. 1.10. Skive outside of black matrix.

1.11. Cut V-Notch in matrix and pull bus wires

from matrix. Cut and remove center

matrix.

Do not cut bus wire strands.

1.12. Apply a liberal amount of RTV sealant to

cable.

1.13. Slide boot onto the end of the cable.

117mm

(4-5/8”)

Bus Wire

Primary Insulation

1.8. Gently score the aluminium foil layer and

peel away. (HSX cables only).

2.1. Cutandremoveheatingcableoverjacket.

2.2. Trim ends of braid. Gently score the

aluminium foil layer (HSX cable only) and

peel away.

13mm

(1/2”)

Cable

Overjacket

2.3. Apply a liberal amount of RTV sealant to

cable and inside end cap. Slide end cap

onto end of cable. For FLX-OJ or HSX

proceed to Step 5.1 on page 6.

End Termination for FLX-OJ Cables and HSX Cables

Aluminium Foil

(HSX Cable Only)

Matrix

Aluminium Foil

(HSX Cable Only)

ET-6C

1 2 3 4 5 6 7 8

Pas de commentaire

Thermon PCA-COM Manuel d'utilisateur Page 4