Thermon PETK-10 Manuel d'utilisateur télécharger pdf (Page 7)

Step 8

Mount the CKTES/PETK on a at surface, with expansion loop of 150 mm in the cables. Heating Cable/Cold Leads

and joint secured in place using bre xing tape. Application of tape shall allow a small degree of movement at the

joint and cables to cater for potential expansion and contraction of the pipeline. Do not over-tighten.

Step 9

Do not move the assembled CKTES/PETK for minimum 24 hours for complete curing.

Installation Instructions 6

150 mm

1 2 3 4 5 6 7 8 9

Pas de commentaire

Thermon PETK-10 Manuel d'utilisateur Page 7